SAM is basically an electro-hydraulically operated sound-seeker.
All technical information about the project can be found on this link SAM website.
My job is to rebuild the electronic circuit that detects the position of the sound and send a corresponding signal which will adjust the position of SAM. I will try to replicate the given circuit diagram as much as possible, however where convenient I will change the circuit to complete the project.
Project Progress:
Sep 09 - Sep 15
- I had to refresh my knowledge of basic electronic components (symbols, what they are used for, output on oscilloscope).
- For initial tests I connected an op-amp to the oscilloscope to see its behavior, first as an inverting amplifier and then as a non-inverting amplifier.
I wanted to understand how the circuit behaves at certain points so I divided the circuit diagram in several phases:
No comments:
Post a Comment